3Com 5102B-EE Network Router User Manual


 
4 - 82 ONline Ethernet Bridge Module Installation and Operation Guide
SET TERMINAL STOP_BITS
Use the SET TERMINAL STOP_BITS command to establish the number of
stop bits between characters when communicating between your terminal
and the Bridge Module.
Format
SET TERMINAL STOP_BITS {stop bits}
Parameters
{stop bits} = 1
2 (default)
Example
This example changes the Bridge Module stop bits parameter to 1.
OEBM> set terminal stop_bits 1 [ENTER]
Terminal parameter changed
Description
The SET TERMINAL STOP_BITS command enables you to establish the
number of stop bits between characters when communicating between
your terminal and the Bridge Module.
The Bridge Module is factory-set to 2 stop bits to signal the end of a
character being received and to reset the line to an idle state. If your
terminal and the Bridge Module do not have the same stop bits setting,
you may lose characters as the terminal receives them from the Bridge
Module.