3Com 5102B-EE Network Router User Manual


 
3 - 14 ONline Ethernet Bridge Module Installation and Operation Guide
Establishing the User Password
Use the SET DEVICE PASSWORD USER command at the management
prompt to establish a user password. Note that you must be logged in as
the administrator to change the user password.
OEBM> set device password user [ENTER]
Enter current administrator password: <current password> [ENTER]
New password: <new user password> [ENTER]
Verify: <new user password> [ENTER]
User password changed.
Configuring Other Bridge Module Parameters
The Bridge Module is factory set to certain default values that you may
need to change before using the Bridge Module, for example the Bridge
Module management prompt. If you are logged in as the administrator,
you can use the SET command to change or add the following Bridge
Module information:
Bridge Module name (alias)
Management prompt
Contact name and location
Terminal timeout value
Concentrator Reboot Values
A full explanation of these values and how you set them is discussed in
Chapter 4 under the applicable SET command.