Filter
Top Products
Management Commands 4 - 49
SET DEVICE IP_ADDRESS_PORT1
Use the SET DEVICE IP_ADDRESS_PORT1 command to set the Internet
Protocol address for port 1 on the Bridge Module.
Note that this command must be used with caution. If used improperly, it
has the potential to disrupt the network.
Format
SET DEVICE IP_ADDRESS_PORT1 {IP address}
Parameter
{IP address} = n.n.n.n
Example
OEBM> set device ip_address_port1 145.36.17.58 [ENTER]
Description
The SET DEVICE IP_ADDRESS_PORT1 command enables you to set the
Internet Protocol address for port 1 on the Bridge Module. The internet
protocol address is entered as n.n.n.n. (four decimal numbers).
Check with your Network Administrator for the next available IP address
that can be assigned to port 1 on your Bridge Module.
The factory default IP address for all Bridge Module ports is the loopback
address (127.0.0.1).