Management Commands 4 - 109
SHOW SPANTREE
Use the SHOW SPANTREE command to display the current Spanning Tree
information for the local bridge.
Note that the values listed for forward_delay_time, hello_time, and
listen_time are active and in effect ONLY when the local bridge is the root
of the Spanning Tree.
Format
SHOW SPANTREE
Parameters
none
Example
OEBM> show spantree [ENTER]
Spanning Tree Parameters:
Mode enabled
Bridge Priority 125
Path Cost Port 1 10
Path Cost Port 2 10
Hello Time (sec) 10
Forward Delay Time (sec) 12
Listen Time (sec) 22
Spantree Hello Address: 01-70-C2-00-00-00
Description
The SHOW SPANTREE command displays current Spanning Tree
configuration information.
These parameters are described in detail in the SET SPANTREE section.
Note that the values listed for forward_delay_time, hello_time, and
listen_time are active and in effect ONLY when the local bridge is the root
of the Spanning Tree. Otherwise, the local bridge, as a non-root bridge,
will operate using the values imposed for these parameters by the current
Root Bridge.