3Com 5102B-EE Network Router User Manual


 
4 - 42 ONline Ethernet Bridge Module Installation and Operation Guide
SET COMMUNITY
Use the SET COMMUNITY command to create an entry in the community
table.
Format
SET COMMUNITY {community} {IP Address} {access}
Parameters
{community} = {community name} or all
{IP Address} = {IP Address} or all
{access} = trap, read_write, read_trap, read_only, or all
All three of the parameter variables are required in the SET COMMUNITY
command line.
Example
The following example creates the community table entry called admin
and specifies that the associated workstation (with IP address 2.13.34.24)
has both read and write access to the Bridge Module variables (through
SNMP) and will receive all traps from the Bridge Module.
OEBM> set community admin 2.13.34.24 all [ENTER]
Community set
Example
The following example gives the workstation with IP address 12.45.65.34
the community name super and enables the person who uses the
workstation read_write access to the Bridge Module variables (through
SNMP).
OEBM> set community super 12.45.65.34 read_write [ENTER]
Community set