3Com 5102B-EE Network Router User Manual


 
Firmware Download Instructions 6 - 5
7. Enter the number of the communications port (COM1, COM2, etc.)
to which you will be connecting the RS-232 cable on the PC to
perform the software download following the “Enter the COM Port
(1-4):” prompt. Then press the Down Arrow key () or [TAB] to move
to the next field.
Note: If you are performing a two-floppy installation, follow Step
8. If you are performing a floppy-to-hard drive installation,
follow Steps 9 and 10.
8. Press [ENTER] if the source and destination drive identifiers and the
COM port selection are correct. Then, insert the ProComm diskette in
the appropr-iate drive and press [ENTER] to install and configure
ProComm directly on the FDK diskette. The floppy installation is
complete when the message “INSTALLATION COMPLETE” displays.
Label the FDK diskette as now having ProComm installed so you can
locate this diskette when necessary.
9. Press [ENTER] if the source and destination drive identifiers and the
COM port selection are correct and the installation process begins.
Insert the ProComm diskette into the diskette drive when prompted
as shown in Figure 6-2.