4 - 50 ONline Ethernet Bridge Module Installation and Operation Guide
SET DEVICE IP_ADDRESS_PORT2
Use the SET DEVICE IP_ADDRESS_PORT2 command to set the Internet
Protocol address for port 2 on the Bridge Module.
Note that this command must be used with caution. If used improperly, it
has the potential to disrupt the network.
Format
SET DEVICE IP_ADDRESS_PORT2 {IP address}
Parameter
{IP address} = n.n.n.n
Example
OEBM> set device ip_address_port2 145.36.17.60 [ENTER]
Description
The SET DEVICE IP_ADDRESS_PORT2 command enables you to set the
Internet Protocol address for port 2 on the Bridge Module. The internet
protocol address is entered as n.n.n.n. (four decimal numbers).
Check with your Network Administrator for the next available IP address
that can be assigned to port 2 on your Bridge Module.
The factory default IP address all Bridge Module ports is the loopback
address (127.0.0.1).