Filter
Top Products
Management Functions 3 - 5
Examining Parameters
The SHOW command lists the current value of any parameter you specify.
For example, the SHOW SPANTREE command displays the current spanning
tree parameters, as shown below.
OEBM> show spantree [ENTER]
Spanning Tree Parameters:
Mode Enabled
Bridge Priority 0
Path Cost Port 1 10
Path Cost Port 2 10
Hello Time (sec) 2
Forward Delay Time (sec) 15
Listen Time (sec) 20
Spantree Hello Address: 01-80-C2-00-00-00
The SHOW DEVICE command displays the current device parameters and
values for the Bridge Module.
OEBM> show device [ENTER]
ONline Ethernet Bridge Module (OEBM); SNMP Management
Name: OEBM
Boot EPROM Version: v1.3 Serial Number: 330658 Restarts: 7
Flash EPROM Version: v2.0 Service Date: / /
Location:
3rd Floor Engineering
Port 1 Port 2
MAC Address: 08-00-8F-10-17-48 08-00-8F-10-17-49
IP address 127.0.0.1 127.0.0.1
Subnet Mask FF.FF.FF.00 FF.FF.FF.00
Default Gateway 0.0.0.0 0.0.0.0
For assistance contact:
Network Administrator
Diagnostics: ENABLED
SQE Mode: NORMAL