Filter
Top Products
4 - 58 ONline Ethernet Bridge Module Installation and Operation Guide
SET FILTER
Use the SET FILTER command to add a protocol ID to the protocol ID table,
set the mode of the protocol ID table, and add an address to the static
address table.
The SET FILTER commands are only available in administrator mode.
Format
SET FILTER {parameter}
Parameter
{parameter} = mode protocol_id_table
protocol_id_table
static_address_table
Description
The SET FILTER command enables you to add a protocol ID to the protocol
ID table, set the mode of the protocol ID table, and add an address to the
static address table.
Since the parameters you can use with the SET FILTER command have
parameters of their own, the following pages describe each parameter.