4 - 62 ONline Ethernet Bridge Module Installation and Operation Guide
Never_Forward_To_Port1 Parameter
Specifying the Never_Forward_To_Port1 parameter with a subsequent
MAC address will result in all frames received at port 2 of the Bridge
Module with the specified MAC address as the destination address being
discarded by the Bridge Module rather than being bridged to port 1.
Never_Forward_To_Port2 Parameter
Similarly, specifying the Never_Forward_To_Port2 parameter with a
subsequent MAC address will result in all frames received at port 1 being
discarded if the destination address matches the specified MAC address.
Once you have selected the parameter you want to use, enter a
hexadecimal MAC address in the following format:
XX-XX-XX-XX-XX-XX
Note that these address changes do not take effect until the changes are
saved and Bridge Module is reset. Therefore, it is recommended that you
enter the SAVE FILTER and RESET DEVICE commands after modifying the
static address table so that these changes take effect as soon as possible.