Document No. 10-300077, Issue 2 19-9
Configuring AppleTalk Routing
CLI Command To edit an AppleTalk interface using the CLI, enter the following command
from Interface mode:
(config-if:<interface-name>)# appletalk <options>
Deleting an AppleTalk Interface
You can delete an AppleTalk interface using either the Web Agent or the
CLI.
Web Agent
Procedure
To delete an AppleTalk interface using the Web Agent:
1. In the navigation pane, expand the Routing > AppleTalk >
Configuration folders, and then click Interfaces.
The AppleTalk Interfaces Web page is displayed in the content pane.
See Figure 19-4.
2. Select the AppleTalk interface that you want to delete from the Select
column.
3. Click DELETE to remove the AppleTalk interface.
CLI Commands Use the following CLI commands in interface mode to delete an AppleTalk
interface:
■ (config-if:<interface-name>)# no appletalk cable-
range <cable-range>
■ (config-if:<interface-name>)# no appletalk address
<network.node>
■ (config-if:<interface-name>)# no appletalk zone
<zone-name>
■ (config-if:<interface-name>)# no appletalk vlan
<vlan-id>
