Filter
Top Products
2 - 38
Chapter 2 Operation of Diag.
4.2.7 Exiting digital output (DO) test
1) Press “CANCEL” key to stop the DO Test.
2) Press “MENU” key to exit the DO Test mode. (“IOT Diag” and “Digital Output” are displayed
after that “Please Wait” was displayed.)
3) Press “CANCEL” key, “IOT Diag” is displayed.
To shift the mode from Diag. mode to the normal mode, perform as follows.
4) Press “ ” key to select “Complete”.
5) Press “ 3 ” key three times to exit the “Diag. Mode.”
4.2.8 How to check the motors, clutches and solenoids
- Parts Location
Ten02002KA