Filter
Top Products
3 - 97
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP4.10 CLUTCH TURN. (PL4.2.9)
[Removal]
1) Remove REGISTRATION ASSEMBLY. (RRP4.6)
2) Disconnect the connector (P/J190) of the CLUTCH TURN (PL4.2.9) from the HARNESS ASSY
FRONTCLH (PL4.2.17).
3) Release the harness of the CLUTCH TURN from the hook of the REGISTRATION
ASSEMBLY.
4) Remove the E-ring that fixes GEAR P1 to ROLL TURN MSI, remove GEAR P1.
5) Pull out CLUTCH TURN from ROLL TURN MSI, then remove it.
[Replacement]
1) Insert CLUTCH TURN into the shaft of ROLL TURN MSI.
2) Fit CLUTCH TURN fixing groove over CLUTCH fixing section of CHUTE REGI.
3) Insert GEAR P1 into the shaft of ROLL TURN MSI and fix it using the E-ring.
4) Attach the harness of the CLUTCH TURN to the hook of the REGISTRATION ASSEMBLY.
5) Connect the connector (P/J190) of the CLUTCH TURN with the HARNESS ASSY
FRONTCLH.
6) Attach REGISTRATION ASSEMBLY. (RRP4.6)