Filter
Top Products
3 - 114
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP5.6 MULTIPURPOSE FEEDER (MPF) SOLENOID. (PL5.3.9)
[Removal]
1) Remove TOP COVER FRAME. (RRP1.1)
2) Remove RIGHT FRONT COVER. (RRP1.8)
3) Remove RIGHT SIDE COVER. (RRP1.7)
4) Release the latch and open OUTER DUPLEX ASSEMBLY (PL5.3.1).
5) Remove the harness, that is connected to MULTIPURPOSE FEEDER (MPF) SOLENOID,
from GUIDE HARNESS F (PL9.1.15) on the right side of the printer. Remove the connector
(P/J132).
Take care not to damage other harnesses when cutting the cable tie following the steps of
procedure described below.
6) Cut out the cable tie binding the harnesses at the right front side of the printer.
7) Remove one screw (silver, tap, 8mm) which fixes MULTIPURPOSE FEEDER (MPF)
SOLENOID and WIRE ASSY DUP EARTH (PL5.3.29) together onto OUTER DUPLEX
ASSEMBLY.
8) Remove MULTIPURPOSE FEEDER (MPF) SOLENOID.
[Replacement]
1) Match the positioning holes of MULTIPURPOSE FEEDER (MPF) SOLENOID to the bosses
at two locations on the right side of OUTER DUPLEX ASSEMBLY, and attach together with
WIRE ASSY DUP EARTH using one screw (silver, tap, 8mm).
2) Put the harness into GUIDE HARNESS F and attach the connector (P/J132).
3) Bind the harnesses located at the right front side of the printer, fix them using the cable tie.
4) Attach RIGHT SIDE COVER. (RRP1.7)
5) Attach RIGHT FRONT COVER. (RRP1.8)
6) Attach TOP COVER FRAME. (RRP1.1)