Filter
Top Products
3 - 147
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP5.18 OUTER DUPLEX ASSEMBLY (PL5.3.1), DUPLEX RETAINING STRAP
(PL5.1.5)
[Replacement]
1) Holding OUTER DUPLEX ASSEMBLY, insert SHAFT PIVOT R and SHAFT PIVOT L.
2) Attach DUPLEX RETAINING DUPLEX HINGE LINK SPRING to OUTER DUPLEX
ASSEMBLY.
3) Attach the two E-rings to SHAFT PIVOT R and SHAFT PIVOT L located under OUTER
DUPLEX ASSEMBLY.
4) Fit the hole in DUPLEX HINGE LINK over the boss on the left side of the printer.
5) Attach DUPLEX HINGE LINK SPRING to the DUPLEX HINGE LINK on the left side of the
printer.
6) Pass the harness through GUIDE HANRNESS F to the right side of the printer.
7) Attach the ground wire to the right side of the bottom plate with a screw (silver, provided with
external tooth washer, 5 mm).
8) Attach the connector (P/J13, P/J22) to MACHINE CONTROL UNIT (MCU).
9) Attach MULTIPURPOSE FEEDER (MPF) COVER. (RRP1.10)
10) Attach MULTIPURPOSE FEEDER (MPF) TRAY. (RRP1.9)
11) Attach LEFT SIDE COVER. (RRP1.12)
12) Attach RIGHT SIDE COVER. (RRP1.7)
13) Attach LEFT FRONT COVER. (RRP1.11)
14) Attach RIGHT FRONT COVER. (RRP1.8)
15) Attach FRONT COVER. (RRP1.3)
16) Attach TOP COVER FRAME. (RRP1.1)