Filter
Top Products
3 - 95
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP4.9 CLUTCH REGI. (PL4.2.7)
[Removal]
1) Remove REGISTRATION ASSEMBLY. (RRP4.6)
2) Disconnect the connector (P/J192) of the CLUTCH REGI (PL4.2.7) from the HARNESS ASSY
FRONTCLH (PL4.2.17).
3) Release the harness of the CLUTCH REGI from the hook of the REGISTRATION
ASSEMBLY.
4) Remove the E-ring that fixes CLUTCH REGI to ROLL REGI RUBBER.
5) Pull out CLUTCH REGI from ROLL REGI RUBBER, then remove it.
[Replacement]
1) Insert CLUTCH REGI into the shaft of ROLL REGI RUBBER.
2) Fit CLUTCH REGI fixing groove over CLUTCH fixing section of CHUTE REGI.
3) Attach the E-ring to ROLL REGI RUBBER.
4) Attach the harness of the CLUTCH REGI to the hook of the REGISTRATION ASSEMBLY.
5) Connect the connector (P/J192) of the CLUTCH REGI with the HARNESS ASSY
FRONTCLH.
6) Attach REGISTRATION ASSEMBLY. (RRP4.6)