Filter
Top Products
3 - 135
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP5.14 ACTUATOR DUP (PL5.4.13)
[Removal]
1) Remove SENSOR PHOTO: JAM. (RRP5.11)
2) Press the shaft of ACTUATOR DUP through the holes at two locations of HOLDER SENSOR
DUP (PL5.4.12) with a miniature screwdriver or the like to remove ACTUATOR DUP.
3) Remove SPRING SENSOR DUP from ACTUATOR DUP.
[Replacement]
• Check to be sure that the direction of replacement of SPRING is correct.
• Be sure to hook SPRING without fail.
1) Attach SPRING SENSOR DUP to ACTUATOR DUP.
2) Put one end of SPRING SENSOR DUP to ACTUATOR DUP and the other end to HOLDER
SENSOR DUP.
3) Attach ACTUATOR DUP in the groove on HOLDER SENSOR.
4) Attach SENSOR PHOTO: JAM. (RRP5.11)