Filter
Top Products
3 - 105
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP5.3 AUTOMATIC DENSITY CONTROL (ADC) SENSOR. (PL5.2.19)
[Removal]
1) Release the latch and open INNER DUPLEX ASSEMBLY (PL5.2.1).
2) Remove TRANSFER ROLLER (PL5.1.4). (RRP5.2)
3) Pinch the hooks at two locations that fixes AUTOMATIC DENSITY CONTROL (ADC)
SENSOR on INNER DUPLEX ASSEMBLY (PL5.2.1) to unlock them, remove AUTOMATIC
DENSITY CONTROL (ADC) SENSOR.
4) Remove the connector (P/J136) that is connected to AUTOMATIC DENSITY CONTROL
(ADC) SENSOR, remove AUTOMATIC DENSITY CONTROL (ADC) SENSOR.
5) Remove SPRING ADC (PL5.2.18) from AUTOMATIC DENSITY CONTROL (ADC) SENSOR.
[Replacement]
1) Attach SPRING ADC to AUTOMATIC DENSITY CONTROL (ADC) SENSOR.
2) Attach the connector (P/J136) to AUTOMATIC DENSITY CONTROL (ADC) SENSOR.
3) Put the harness on the connector (P/J136) through the harness guide located under
AUTOMATIC DENSITY CONTROL (ADC) SENSOR.
4) Pinching the hooks at two locations on AUTOMATIC DENSITY CONTROL (ADC) SENSOR,
insert AUTOMATIC DENSITY CONTROL (ADC) SENSOR into the mounting holes in
INNER DUPLEX ASSEMBLY and lock the hooks.
5) Attach TRANSFER ROLLER. (RRP5.2)
6) Close INNER DUPLEX ASSEMBLY.