Filter
Top Products
3 - 211
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP9.9 HIGH VOLTAGE POWER SUPPLY (HVPS) (PL9.1.21)
[Removal]
1) Remove TOP COVER FRAME. (RRP1.1)
2) Remove LEFT SIDE COVER. (RRP1.12)
3) Remove two screws (silver, tap, 10mm) and three screws (silver, 6mm) fixing HIGH
VOLTAGE POWER SUPPLY (HVPS) from the left side of the printer.
4) Separate the HIGH VOLTAGE POWER SUPPLY (HVPS) a little from the left face side of the
printer and remove the connector (P/J141), WIRE ASSY BTR and WIRE ASSY REGI.
5) Remove HIGH VOLTAGE POWER SUPPLY (HVPS) from the left side of the printer.
[Replacement]
1) Connect the connector (P/J141), WIRE ASSY BTR and WIRE ASSY REGI to the HIGH
VOLTAGE POWER SUPPLY (HVPS).
2) Match the holes in HIGH VOLTAGE POWER SUPPLY (HVPS) with the bosses at two
locations on the left side of the printer.
3) Attach HIGH VOLTAGE POWER SUPPLY (HVPS) with two screws (silver, tap, 10mm) and
three screws (silver, 6mm) on the left face side of the printer.
4) Attach LEFT SIDE COVER. (RRP1.12)
5) Attach TOP COVER FRAME. (RRP1.1)