Filter
Top Products
To set the number of rings before answering from the control panel
1. Press Setup.
2. Press 4, and then press 3.
This selects Basic Fax Setup and then selects Rings to Answer.
3. Enter the appropriate number of rings by using the keypad, or press
or to
change the number of rings.
4. Press OK to accept the setting.
Cause: The HP All-in-One is set up to receive faxes manually, which means that
the HP All-in-One will not answer incoming calls. You must be available to respond
in person to incoming fax calls, or the HP All-in-One will not receive the fax and your
answering machine will record the fax tones.
Solution: Set up the HP All-in-One to answer incoming calls automatically by
turning on Auto Answer. If it is turned off, the HP All-in-One will not monitor incoming
calls and receive faxes. In this case, the answering machine will answer the fax call
and record the fax tones.
For more information on setting up the HP All-in-One when you have an answering
machine, see
Set up the HP All-in-One for faxing.
The HP All-in-One is not answering incoming fax calls
Cause: The HP All-in-One is turned off.
Solution: Look at the display on the HP All-in-One. If the display is blank and the
Power button is not lit, the HP All-in-One is turned off. Make sure the power cord is
firmly connected to the HP All-in-One and plugged into a power outlet. Press the
Power button to turn on the HP All-in-One.
Cause: Auto Answer is turned off, which means that the HP All-in-One will not
answer incoming calls. You must be available to respond in person to incoming fax
calls, or the HP All-in-One will not answer the incoming fax call.
Solution: Depending on your office setup, you might be able to set the HP All-in-
One to answer incoming calls automatically. To find out what the recommended
answer mode is for your office setup, see
Choose the recommended answer mode
for your setup.
If you must have Auto Answer off, you will need to press Start Fax Black or Start
Fax Color to receive a fax.
TIP: If you are not close enough to the HP All-in-One to reach the control panel,
wait several seconds, and then press 1 2 3 on your phone. If the HP All-in-One
does not begin receiving the fax, wait several more seconds and press 1 2 3 again.
After the HP All-in-One begins to receive the fax, you can hang up the phone.
Cause: You have a special ring pattern for your fax phone number (using a
distinctive ring service through your telephone company), and the Distinctive Ring
setting on the HP All-in-One does not match.
Chapter 12
196 Troubleshooting