HP (Hewlett-Packard) 5700J Printer User Manual


 
Network compatibility depends on customer selected settings, which must be reset to use the
equipment on a telephone network in a country/region other than where the product was purchased.
Contact the vendor or Hewlett-Packard Company if additional product support is necessary.
This equipment has been certified by the manufacturer in accordance with Directive 1999/5/EC
(annex II) for Pan-European single-terminal connection to the public switched telephone network
(PSTN). However, due to differences between the individual PSTNs provided in different countries,
the approval does not, of itself, give an unconditional assurance of successful operation on every
PSTN network termination point.
In the event of problems, you should contact your equipment supplier in the first instance.
This equipment is designed for DTMF tone dialing and loop disconnect dialing. In the unlikely event
of problems with loop disconnect dialing, it is recommended to use this equipment only with the
DTMF tone dial setting.
Notice to users of the German telephone network
This HP fax product is designed to connect only to the analogue public-switched telephone network
(PSTN). Please connect the TAE N telephone connector plug, provided with the HP All-in-One into
the wall socket (TAE 6) code N. This HP fax product can be used as a single device and/or in
combination (in serial connection) with other approved terminal equipment.
Geräuschemission
LpA < 70 dB am Arbeitsplatz im Normalbetrieb nach DIN 45635 T. 19
Notice to users in Korea
Australia Wired Fax Statement
Declaration of conformity (European Economic Area)
The Declaration of Conformity in this document complies with ISO/IEC Guide 17050-1 and EN
17050-1. It identifies the product, manufacturer's name and address, and applicable specifications
recognized in the European community.
Chapter 15
274 Technical information