Filter
Top Products
Chapter 2: Installing and Configuring the EMX Device
14
Connecting the EMX to Your Network
To use the web interface to administer the EMX, you must connect the
EMX to your local area network (LAN). The EMX can be connected to a
wired or wireless network.
To make a wired connection:
1. Connect a standard Category 5e/6 UTP cable to the ETHERNET
port on the EMX.
2. Connect the other end of the cable to your LAN.
To make a wireless connection:
Do one of the following:
Plug a 802.11n wireless USB LAN adapter into the USB-A port
on your EMX.
Connect a USB docking station to the USB-A port on the EMX
and plug the 802.11n wireless USB LAN adapter into the
appropriate USB port on the docking station.
Supported Wireless LAN Configuration
If you select the wireless connection, ensure that both of your wireless
USB LAN adapter and wireless network configuration meet the following
requirements.
Network type: 802.11n
Protocol: WPA2 (RSN)
Key management: WPA-PSK
Encryption: CCMP (AES)
Important: Currently only Raritan-provided wireless USB LAN
adapters are supported. You may contact Raritan Technical
Support for this information.