Filter
Top Products
Chapter 10: Using the Command Line Interface
234
For more information, see Setting Data Logging (on page 176).
Example
The following command enables the data logging feature.
config:#
emd dataRetrieval enable
Setting the Data Logging Measurements Per Entry
This command syntax defines the number of measurements
accumulated per log entry.
config:#
emd measurementsPerLogEntry <number>
Variables:
<number> is an integer between 1 and 600. The default is 60
samples per log entry.
For more information, see Setting Data Logging (on page 176).
Example
The following command determines that 66 measurements are
accumulated per log entry for sensors, that is, 66 seconds.
config:#
emd measurementsPerLogEntry 66
Networking Configuration Commands
A network configuration command begins with network. A number of
network settings can be changed through the CLI, such as the IP
address, transmission speed, duplex mode, and so on.