Filter
Top Products
Chapter 5: EMX Device Management
83
Note: The EMX supports a maximum of 3 DNS servers. If two IPv4 DNS
servers and two IPv6 DNS servers are available, the EMX only uses the
primary IPv4 and IPv6 DNS servers.
Modifying the IPv6 Settings
You must enable the IPv6 protocol before you can modify the IPv6
network settings. See Selecting the Internet Protocol (on page 81).
To modify the IPv6 settings:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
2. Click the IPv6 Settings tab.
3. In the IP Auto Configuration field, click the drop-down arrow, and
select the desired option from the list.
Option
Description
Automatic
To auto-configure EMX, select Automatic.
With this option selected, you can enter a preferred host
name, which is optional. Type the host name in the
Preferred Hostname field.
The host name:
Consists of alphanumeric characters and/or
hyphens
Cannot begin or end with a hyphen
Cannot contain more than 63 characters
Cannot contain punctuation marks, spaces, and
other symbols
Select the "Specify DNS server manually" checkbox if
necessary. Then type the address of the primary DNS
server in the Primary DNS Server field. The secondary
DNS server and DNS suffix are optional.
Static
To manually assign an IP address, select Static, and enter
the following information in the corresponding fields:
IP address
Gateway
Primary DNS server
Secondary DNS server (optional)
DNS Suffix (optional)
4. Click OK to save the changes.