Filter
Top Products
Chapter 5: EMX Device Management
82
Modifying the IPv4 Settings
You must enable the IPv4 protocol before you can modify the IPv4
network settings. See Selecting the Internet Protocol (on page 81).
To modify the IPv4 settings:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
2. Click the IPv4 Settings tab.
3. In the IP Auto Configuration field, click the drop-down arrow, and
select the desired option from the list.
Option
Description
DHCP
To auto-configure the EMX, select DHCP.
With DHCP selected, you can enter a preferred DHCP host
name, which is optional. Type the host name in the
Preferred Hostname field.
The host name:
Consists of alphanumeric characters and/or hyphens
Cannot begin or end with a hyphen
Cannot contain more than 63 characters
Cannot contain punctuation marks, spaces, and
other symbols
Note: If the Service
Select the "Specify DNS server manually" checkbox if
necessary. Then type the address of the primary DNS
server in the Primary DNS Server field. The secondary DNS
server and DNS suffix are optional.
Static
To manually assign an IP address, select Static, and enter
the following information in the corresponding fields:
IP address
Netmask
Gateway
Primary DNS server
Secondary DNS server (optional)
DNS Suffix (optional)
4. Click OK to save the changes.