Filter
Top Products
Chapter 5: EMX Device Management
88
8. To create an SNMP TRAP or INFORM communication, open the
Notifications tab on the SNMP Settings dialog.
9. Select the Enabled checkbox to enable the feature.
For SNMPv2/c TRAP and INFORM notifications:
1. From the Notification Type drop-down, select the type of SNMP
notification.
2. For SNMP INFORM communications, leave the resend settings at
their default or:
a. In the Timeout (sec) field, enter the interval of time, in seconds,
after which a new inform communication is resent if the first is
not received. For example, resend a new inform communication
once every 3 seconds.
b. In the Number of Retries field, enter the number of times you
want to resend the inform communication if it fails. For example,
inform communications are resent up to 5 times when the initial
communication fails.
3. In the Host fields, enter the IP address of the device(s) you want to
access. This is the address to which notifications are sent by the
SNMP system agent. You can specify up to 3 SNMP destinations.
4. In the Port fields, enter the port number used to access the
device(s).