Filter
Top Products
Chapter 3: Getting Started
51
Contact Closure Sensor Termination
Two channels for connecting two third-party contact closure sensors are
provided on the EMX2-888 model.
For more information, see:
Connecting Third-Party Detectors/Switches to the EMX (on page
38)
Contact Closure Sensor LEDs (on page 39)
Power Switch
The power switch turns on or off the EMX device.
To power cycle the EMX, press the power switch to turn off the device,
wait at least 10 seconds and then press the power switch again to turn
it on. Note that a minimum of 10-second power-off period is required, or
the device may not boot up properly.
Logging In
To log in to the web interface, you must enter a user name and
password. The first time you log in to the EMX, use the default user
name (admin) and password (raritan). You are then prompted to change
the password for security purposes.
Exception: If you already changed the password for the admin account
during the Initial Network Configuration (on page 15), use the new
password instead to log in to the web interface, and the EMX will NOT
prompt you to change the password.
After successfully logging in, you can create user profiles for your other
users. These profiles define their login names and passwords. See
Creating a User Profile (on page 62).
If a security login agreement has been enabled, you must accept the
agreement in order to complete the login. The security agreement
appears in the same dialog as the login credential requirements. See
Enabling and Editing the Security Banner (Restrictive Service
Agreement Banner) (on page 129) for more information.
The web interface allows a maximum of 16 users to log in
simultaneously.
You must enable JavaScript in the web browser for proper operation.
To log in to the web interface:
1. Open a browser, such as Microsoft Internet Explorer or Mozilla
Firefox, and type this URL: