Filter
Top Products
Chapter 3: Getting Started
50
MAC Address
The EMX's MAC address is available by operating the LCD display, and
in Device mode. Contact your LAN administrator for assistance.
To display the MAC address:
1. Press the MODE button until the device settings are displayed,
indicated by a 'd' in at the top left of the display.
2. Press the Function button below the Mode button one time to change
from the IP address to MAC address mode. The character "M"
appears in the left side of the LCD display.
3. The MAC address is displayed as "M:XX", where XX are two digits of
the MAC address. The LCD will cycle through the MAC address from
the first two digits to the final two.
For example, if the MAC address is 00:0d:5d:03:5E:1A, the LCD
display shows the following information one after another:
M:00 --> M:0d --> M:5d --> M:03 --> M:5E --> M:1A
Reset Button
The reset button is located inside a small hole which is labeled RESET.
The EMX device can be reset to its factory default values using this
button when a serial connection is available. See Resetting to Factory
Defaults (on page 102).
Without the serial connection, pressing this reset button restarts the EMX
device's software.