Filter
Top Products
Chapter 5: EMX Device Management
81
Selecting the Internet Protocol
The EMX device supports two types of Internet protocols -- IPv4 and
IPv6. You can enable either or both Internet protocols. After enabling the
desired Internet protocol(s), all but not limited to the following protocols
will be compliant with the enabled Internet protocol(s):
LDAP
NTP
SMTP
SSH
Telnet
FTP
SSL
SNMP
SysLog
To select the appropriate Internet Protocol:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
2. Click the IP Protocol tab.
3. Select one checkbox according to the Internet protocol(s) you want
to enable:
IPv4 only: Enables IPv4 only on all interfaces. This is the default.
IPv6 only: Enables IPv6 only on all interfaces.
IPv4 and IPv6: Enables both IPv4 and IPv6 on all interfaces.
4. If you selected the "IPv4 and IPv6" checkbox in the previous step,
you must determine which IP address is used when the DNS
resolver returns both of IPv4 and IPv6 addresses.
IPv4 Address: Use the IPv4 addresses returned by the DNS
server.
IPv6 Address: Use the IPv6 addresses returned by the DNS
server.
5. Click OK to save the changes.