Filter
Top Products
Chapter 2: Installing and Configuring the EMX Device
20
where <option> is enable or disable. See the table below for the
IPv6 commands for manually specifying DNS servers.
For the static IPv6 configuration, you should configure the
following parameters. Note that the IP address must follow
the IPv6 format.
To set
Use this command
Static IPv6
address
network ipv6 ipAddress <ip
address>
where <ip address> is the IP address
you want to assign.
Gateway
network ipv6 gateway <ip
address>
where <ip address> is the IP address
of the gateway.
Primary DNS
server
network ipv6
primaryDNSServer <ip
address>
where <ip address> is the IP address
of the primary DNS server.
Secondary
DNS server
(optional)
network ipv6
secondaryDNSServer <ip
address>
where <ip address> is the IP address
of the secondary DNS server.
9. To quit the configuration mode with or without saving the changes,
type either command, and press Enter.
Command
Description
apply
Save all configuration changes and quit
the configuration mode.
cancel
Abort all configuration changes and quit
the configuration mode.
The # prompt appears, indicating that you have quit the configuration
mode.