Filter
Top Products
Chapter 2: Installing and Configuring the EMX Device
29
b. Connect the other end of the cable to the FEATURE port on the
EMX.
2. Affix an asset tag to the IT device and connect this asset tag to the
AMS-M2-Z by plugging the tag connector into the tag port on the
AMS-M2-Z. See Connecting Asset Sensors to the EMX (on page
24) for details.
3. If necessary, daisy chain multiple AMS-M2-Z to track more than two
IT devices via this EMX.
a. Verify that the Category 5e/6 cable length is within the limitation.
See AMS-M2-Z Daisy-Chain Limitations (on page 334) for the
cable length limitations.
b. Connect one end of the Category 5e/6 cable to the RJ-45
connector labeled "Output" on the AMS-M2-Z being connected to
the EMX.
c. Connect the other end of the cable to the RJ-45 connector
labeled "Input" on another AMS-M2-Z.
d. Repeat the above steps to daisy chain additional AMS-M2-Z.
See AMS-M2-Z Daisy-Chain Limitations (on page 334) for the
maximum number of AMS-M2-Z asset sensors supported in the
chain.
e. It is highly recommended using the cable ties to help hold the
weight of all connecting cables.
4. Repeat Step 2 to connect IT devices to the other AMS-M2-Z's in the
chain via the asset tags.