Filter
Top Products
Chapter 10: Using the Command Line Interface
315
Specifying the Rack Unit Numbering Offset
This command syntax specifies the starting number of rack units on the
asset sensors connected to the EMX device.
config:#
assetStrip <n> rackUnitNumberingOffset <number>
Variables:
<n> is the number of the FEATURE port where the selected asset
sensor is physically connected. For the EMX device with only one
FEATURE port, the number is always 1.
<number> is a starting number for numbering rack units on the
connected asset sensor. This value is an integer number.
Example
The following command specifies the starting number of rack units of the
asset sensor #1 to be 5. That is, the rack units are numbered 5, 6, 7 and
so on from the first to the final rack unit on the asset sensor #1.
config:#
assetStrip 1 rackUnitNumberingOffset 5
Specifying the Asset Sensor Orientation
This command syntax specifies the orientation of the asset sensors
connected to the EMX device. Usually you do not need to perform this
command unless your asset sensors do NOT come with the tilt sensor,
causing the EMX unable to detect the asset sensors' orientation.
config:#
assetStrip <n> assetStripOrientation <orientation>
Variables:
<n> is the number of the FEATURE port where the selected asset
sensor is physically connected. For the EMX device with only one
FEATURE port, the number is always 1.
<orientation> is one of the options: topConnector or
bottomConnector.
Orientation
Description
topConnector
This option indicates that the asset sensor is
mounted with the RJ-45 connector located on
the top.