Filter
Top Products
Chapter 10: Using the Command Line Interface
318
Setting the LED Disconnect Color
This command syntax sets the LED color for all rack units on the
connected asset sensor(s) to indicate the absence of a connected asset
tag.
config:#
assetStrip <n> LEDColorForDisconnectedTags <color>
Setting an LED Color for a Rack Unit
This command syntax sets the LED color for a specific rack unit on the
specified asset sensor. You need to set a rack unit's LED color only
when the LED operation mode of this rack unit has been set to "manual."
config:#
rackUnit <n> <rack_unit> LEDColor <color>
Variables:
<n> is the number of the FEATURE port where the selected asset
sensor is physically connected. For the EMX device with only one
FEATURE port, the number is always 1.
<rack_unit> is the index number of the desired rack unit. The index
number of each rack unit is available on the Asset Strip page of the
web interface.
<color> is the hexadecimal RGB value of a color in HTML format.
The <color> variable ranges from #000000 to #FFFFFF.
Note: A rack unit's LED color setting overrides the global LED color
setting on it. See Global LED Color Settings.
Example
The following command sets the LED color of the rack unit whose index
number is 25 on the asset sensor#1 to PINK (that is, FF00FF).
config:#
rackUnit 1 25 LEDColor #FF00FF