Filter
Top Products
Appendix
152
7
Spool Printing
With spool printing, the whole data of a print job is saved in the Printer Hard
Disk before printing. To use this function, set it from the menu. See p.124 “Sys-
tem Menu”.
Important
❒ Do not turn off the printer or the computer when a print job is being spooled
and the Data In indicator is blinking. If you do, the print job will remain in
the Printer Hard Disk and be printed when the printer is turned on.
Limitation
❒ Spool printing does not appear unless the optional Hard Disk Drive is in-
stalled.
❒ Data that has been received in the protocol other than LPD or IPP cannot be
spooled.
❒ Up to 50 jobs (approximately 500 MB) can be spooled at a time.
❒ When spool printing is on, the size of a single print job cannot exceed 500 MB.
❒ When sending spooled print jobs from more than one computer at the same
time, up to five LPR jobs and one IPP job can be spooled. Jobs exceeding the
maximum number cannot be spooled. Wait until the number of spooled print
jobs falls below the maximum.
Note
❒ When "On" is selected, the first print will take time.
❖
❖❖
❖ Confirm or delete the spooled job from a Web browser.
The spooled job can be seen or deleted from a Web browser. Start a Web
browser, and then input the IP address of the printer for URL to show the top
page. Click [Admin Info.], and then click [Spool Printing]. Select the file, check for
delete, input the password, and then click the delete button. (The default
password is "password".)