Filter
Top Products
NetWare 4.x, 5/5.1 - Advanced Settings
61
5
Setting Up as a Print Server
Important
❒ You can set up the print server using the NDS or Bindery mode in NetWare
4.x, 5/5.1. The following procedure is for setting up the print server using the
NDS mode in NetWare 4.1. When you set up the print server using the Bind-
ery mode, use the NIB Setup Tool Wizard. See p.51 “Quick Setup Using the
NIB Setup Tool Wizard”.
Note
❒ If you use Pure IP in NetWare 5/5.1, follow the procedure on p.63 “Using
Pure IP in the NetWare 5/5.1 environment”.
A
AA
A
Log on to the file server as an Admin or an Admin equivalent.
B
BB
B
Run the NIB Setup Tool.
Reference
See p.50 “Running the NIB Setup Tool” .
C
CC
C
Click [Property Sheet] and click [OK].
D
DD
D
Click [IPX protocol].
E
EE
E
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see the network configuration page to check the MAC address (Network
Address).
F
FF
F
Make sure that the MAC address and IPX address are correct, and then click
[Finish].
The [NIB Setup Tool] window appears.
G
GG
G
Click [Configure].
The property sheet appears.
H
HH
H
Click the [General] tab, and then type the name of the print server into the
[Device Name] box.
I
II
I
Click the [NetWare] tab, and then make the following settings.
A In the [Print Sever Name:] box, type the name of the print sever.
B In the [File Sever Name:] box, type the name of the file sever in which a
print server is to be created.
Clicking [Browse], you can select a file server among those listed in the
[Browse] dialog box.