Filter
Top Products
Remote Maintenance by telnet
103
7
Job Spool
Use this command to configure Job Spool settings.
Limitation
❒ You can only specify the LPR and IPP protocol.
Note
❒ This machine information cannot reload automatically when you confirm the
Job spool settings on the Web browser. Click [Reload] or [Refresh] on the Web
browser when you want to reload this machine information.
❖
❖❖
❖ Reference
The job spool setting appears.
msh> spoolsw
channel frequency channel no. You can set the channel.
You can specify from following channel.
• Metric Version :1-13
• Inch Version :1-11
Set the same channel for all the machines you
are using.
enc [on|off] You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.
key [
key value
] Only 10 hexadecimal characters can be used.
To use this function, set the same WEP key
for all the ports that transmit to each other.
auth [open|shared] You can set the authorized mode when using
WEP. The specified value and the authorized
mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
rate [auto|11m|5.5m|2m|1m] You can set the IEEE 802.11b transmitting
speed.
The transmitting speed you specify here is
the speed at which data is sent. You can re-
ceive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Parameter Value to be configured