Filter
Top Products
Appendix
92
7
Remote Maintenance by telnet
You can view the printer status and configure the Network Interface Board us-
ing telnet.
Note
❒ You should specify a password so that only the network administrator, or a
person having network administrator privileges, can use remote maintenance.
Using telnet
The following is a sample procedure using telnet.
Limitation
❒ Only one person at a time can be logged on to do remote maintenance.
A
AA
A
Using the IP address or host name of the machine, start telnet.
% telnet IP_address
Note
❒ In order to use the host name instead of the IP address, you must write it
to the hosts file.
B
BB
B
Type the password.
Note
❒ The default is “password”.
C
CC
C
Type a command.
Reference
For more information about telnet commands, see p.93 “Commands List”.
D
DD
D
Exit telnet.
msh> logout
When the configuration is changed, a message requests whether or not the
changes should be saved.
E
EE
E
Type “yes” to save the changes, and then press the {
{{
{ENTER}
}}
} key.
If you do not want to save the changes, type “no”, and then press the {
{{
{ENTER}
}}
}
key. If you want to make additional changes, type “return” at the command
line, and then press the {
{{
{ENTER}
}}
} key.
Note
❒ If the “Cannot write NVRAM information” message appears, the changes
are not saved. Repeat the steps above.
❒ The Network Interface Board is reset automatically when the settings are
changed.