Filter
Top Products
Network Interface Board Type 2610
21
2
Network Interface Board Type 2610
Note
❒ Depending on the model you use,
the Network Interface Board , the
1394 Interface Unit, and the
802.11b Interface Unit cannot be
installed to the printer at the same
time. For more information, see
p.11 “Installing Options”.
Important
❒ Before touching the Network In-
terface Board, touch something
metal to discharge any static elec-
tricity. Static electricity can dam-
age the Network Interface Board.
❒ Use the shielded twisted-pair
(STP) network interface cable.
Installing the Network
Interface Board
A
AA
A
Check the contents of the box for
the following items:
• Network Interface Board
• Ferrite Core
• Installation Guide
B
BB
B
Confirm that the followings are
true:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
Note
❒ The interface cable is not includ-
ed in the box. Make sure that the
interface cable you use is appro-
priate for your computer.
❒ If the Duplex Unit is not at-
tached, go to step
D
.
C
CC
C
If the Duplex Unit is attached,
push down the lever on right side
(A
AA
A) and pull out the Duplex Unit
until it stops (B
BB
B).
D
DD
D
Use a coin to remove the two
screws.
Note
❒ These screws are used again in
step
M
.
ZGDX320J
ZGDX281J