Filter
Top Products
NetWare 3.x - Advanced Settings
57
5
O
OO
O
Press the {
{{
{ESC}
}}
} key until “Exit?” appears, and then select [Yes] to exit
PCONSOLE.
Note
❒ To make sure that the printer is correctly configured, type the following
from the command prompt.
F:> USERLIST
❒ If the printer works as configured, the name of the print server appears as
an attached user.
Setting Up as a Remote Printer
A
AA
A
Log on to the file server as a Supervisor or a Supervisor equivalent.
B
BB
B
Run the NIB Setup Tool.
Reference
See p.50 “Running the NIB Setup Tool” .
C
CC
C
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
D
DD
D
Click [IPX protocol].
E
EE
E
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see a network configuration page to check the MAC address (Network Ad-
dress).
F
FF
F
Make sure that the MAC address and IPX address are correct, and then click
[Finish].
The [NIB Setup Tool] window appears.
G
GG
G
Click [Configure].
The property sheet appears.
H
HH
H
Click the [General] tab, and then type the name of the print server into the
[Device Name] box.
I
II
I
Click the [NetWare] tab, and then make the following settings.
A In the [Print Server Name] box, type the name of the print server.