Filter
Top Products
Remote Maintenance by telnet
93
7
❒ When the Network Interface Board is reset, the active print job which has
already been sent to the machine will finish printing. However, jobs that
have not been sent yet will be canceled.
Commands List
Use this command to display remote maintenance use.
Note
❒ Type “help” to see a list of commands that can be used.
msh> help
❒ Type “help command_name” to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the ifconfig command to configure TCP/IP (IP address, subnet mask, broad-
cast address, default gateway address) for the machine.
❖
❖❖
❖ Reference
msh> ifconfig
❖
❖❖
❖ Configuration
msh> ifconfig interface_name parameter address
*1
If you did not enter the interface name, it will be automatically set to the Ethernet
interface.
*2
Available when the 1394 Interface Unit Type 4510 is installed.
*3
You can specify an interface when installing the optional 802.11b Interface Unit
Type A.
Interface name Interface to be configured
ether
naf0
Ethernet Interface
*1
ip1394
*2
fwip0
*2
IEEE 1394 Interface
wlan
*3
wi0
*3
IEEE 802.11b Interface
Parameter Meaning
(no parameter) IP address
netmask subnet mask
broadcast broadcast address