Filter
Top Products
e-STUDIO281c/351c/451c ADJUSTMENT June 2005 © TOSHIBA TEC
3 - 46
3.7.9 Fine adjustment of black density
The density of black side on scanned image is adjusted at color-scanning.
<Adjustment Mode (05)>
Note: Note:
Be careful for the value not to be too large since the gradation is reproduced worse in darker
side.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values : 0 to 4. (To correct the value once keyed in,
press [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory. ? The equipment goes
back to the ready state.
(5) Let the equipment restart and perform scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
3.7.10 RGB conversion method selection
The color space conversion method of image is decided at color-scanning.
<Adjustment Mode (05)>
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values : 0 to 3. (To correct the value once keyed in,
press [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory. ? The equipment goes
back to the ready state.
(5) Let the equipment restart and perform scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
Code Original mode Remarks
1075 Text The larger the value is, the black side of the image becomes darker.
Acceptable values: 0 to 4 (Default: 0)
1076 Printed Image
1077 Photo
Code Original mode Remarks
1080 Text Remarks
0: sRGB, 1: AppleRGB, 2: ROMMRGB, 3: AdobeRGB
(Default: 0)
1081 Printed Image
1082 Photo