Filter
Top Products
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c FIRMWARE UPDATING
6 - 3
6
PWA-DWNLD-350-JIG2 (48MB)
Fig.6-1 Jig board: PWA-DWNLD-350-JIG2 (48 MB)
Important:
• To perform update, two download jigs (PWA-DWNLD-350-JIG2) are needed.
• The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on
the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the
data to these Flash ROMs. Refer to the following to write the data.
P.6-13 "6.1.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
K-PWA-DLM-320
Fig.6-2 Jig board: K-PWA-DLM-320
Important:
Pay attention to the direction of the ROM.
ROM4
ROM5
ROM6
ROM1
ROM2
ROM3
Connector
(
for SYS board
connection
)
Connector
(
for ROM writer
adapter connection
)
Connector Mark for ROM
installation direction
ROM
LED