Filter
Top Products
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c ADJUSTMENT
3 - 91
3
(9) After confirming that the staple position is adjusted correctly, place a sheet of paper between the
alignment plates and push it against the stopper and push the rear edge of the paper against the
rear alignment plate. Then press SW103 once. (Stapling is performed and the adjustment value
is stored in memory.)
• The staple position adjustment is completed.
(10) Turn OFF all bits of SW104 on the finisher controller PC board.
(11) Turn OFF the power and install the rear cover of the finisher unit.
3.14.3 Adjusting the folding position (Saddle stitcher unit)
The folding position is adjusted by changing setting of bits 6 through 8 of SW504 on the saddle stitcher
controller PC board to match the stitching position (adjusting the distance over which the paper posi-
tioning plate is moved to the folding position from the stitching position).
If you have replaced the saddle stitcher controller PC board, be sure to set the new SW504 so that the
settings will be the same as those on the old SW504. Perform this adjustment if, for any reason, you
must change the folding position.
(1) Check that the power is OFF and separate the finisher from the host machine. If the optional
puncher unit is installed, remove it from the finisher.
(2) Remove the PC board cover and set bits 1 through 4 of SW504 on the saddle stitcher controller
PC board as follows:
Fig.3-87
(3) Remove the rear cover, open the inlet cover of the saddle stitcher unit and tape the actuator of
inlet cover sensor (PI9) and inlet door switch (SW1).
ON
12345678
Do not change bits 5 through 8.