Filter
Top Products
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c ADJUSTMENT
3 - 81
3
3.13.3 Adjusting the overlap of the sensor flag
If the overlap between the sensor and the flag is wrong for some reason, perform the following adjust-
ment.
(1) Remove the processing tray unit.
(2) Loosen the mounting screw of the front/rear
jogging plate adjusting plate; then, move the
adjusting plate to the left and the right.
Fig.3-73
(3) Tighten the screw so that the overlap
between the flag of the front/rear jogging
rack plate and the sensor is 1.5 mm to 2.0
mm.
Fig.3-74
Jogging plate
adjusting plate
Screw
Adjusting plate
Screw
Jogging plate
adjusting plate
Adjusting plate
Sensor Sensor flag
1.5 mm to 2.0 mm