Filter
Top Products
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c ADJUSTMENT
3 - 51
3
(3) Assembling carriage wires
Winding the wire around the wire pulley:
• Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley.
One end of the wire with a hook attached comes to the outside.
• Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
- 2 turns toward the opposite side of the boss
- 4 turns toward the boss side
Notes:
Pay attention to the followings when the wires are wound around the pulleys:
• Do not twist the wire.
• Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
• Each turn should be pushed against the previously wound turn so that there is no space
between them.
Fig.3-18
• After winding the wires around the pulleys, attach the wire holder jigs not to loosen the wires.
2 turns 4 turns 2 turns4 turns
No space between turns
Ball terminalBall terminal
Color: Black
Color: Silver
Hook
Hook
[
Rear
][
Front
]