Filter
Top Products
432 AlterPath KVM/net Installation, Administration, and User’s Guide
4. If the memory test (RAM) is being performed, press <ESC> to bypass it.
By default the “Testing RAM” is set to skip.
5. If the storage device test is being performed, press <ESC> to bypass it. By
default the “Testing Storage Device” is set to skip.
6. Press <ESC> when the “Testing Ethernet” prompt appears.
7. Complete the following system parameters.
a. At the following prompt press [Enter] to accept the default value
(Active), or “I” to inactivate watchdog timer.
b. Enter “N” to boot from the network. By default the firmware is set to
boot from flash.
c. Select the boot type at the following prompt.
d. Enter the boot file name. This is the image you downloaded from the
Cyclades FTP server.
For example, zImage_kvm_200.bin
Testing RAM .............................. FULL TEST
This test takes a few seconds.
Press <ESC> if you want to cancel it.
Memory detected: 131072 Kbytes
WARNING! Memory not checked.
Testing Storage Device [Op Code] ......... SKIPPED
Testing Ethernet ......................... OK
Watchdog timer ((A)ctive or (I)nactive) [A] :
Firmware boot from ((F)lash or (N)etwork) [F] :
Boot type ((B)ootp,(T)ftp or Bot(H)) [T] :
Boot File Name [zvmppckvm.bin] :