Filter
Top Products
444 AlterPath KVM/net Installation, Administration, and User’s Guide
Execute the following script, replacing the parameters with values
appropriate for your system. The
gw and mask parameters are optional.
b. Using the “vi editor”, edit the file(s) causing the problem and then
reboot the unit.
c. Check your DNS configuration in the file
/etc/resolv.conf, and
download the zImage using the
ftp command. See "To Save the
zImage into the KVM/net’s Flash Memory."
How to Restore the KVM/net’s Configuration to
Factory Default
This procedure assumes that the saveconf command has been previously run
to save the configuration.
While logged in as root through the console, via Telnet, or via any SSH
session, enter the following command.
[root@(none)]# config_eth0 ip 192.168.51.242 mask
255.255.255.0 gw 192.168.51.1
[root@(none) root]# saveconf
[root@(none) root]# reboot
[root@KVM/net root]# echo 0>/proc/flash/script
[root@KVM/net root]# reboot