Filter
Top Products
Configuration and Installation Chapter 2
Lab-PC+ User Manual 2-14 © National Instruments Corporation
•
•
•
A
B
C
W3
B
U
Figure 2-12. Bipolar Input Jumper Configuration (Factory Setting)
Unipolar Input Selection
You can select the unipolar (0 to 10 V) input configuration by setting the following jumper:
Analog Input W3 B-C
This configuration is shown in Figure 2-13.
•
•
•
A
B
C
W3
B
U
Figure 2-13. Unipolar Input Jumper Configuration
Note: If you are using a software package such as NI-DAQ or LabWindows/CVI, you may
need to reconfigure your software to reflect any changes in jumper or switch settings.