Filter
Top Products
© National Instruments Corporation 3-1 Lab-PC+ User Manual
Chapter 3
Signal Connections
This chapter describes how to make input and output signal connections to your Lab-PC+ board
via the board I/O connector.
I/O Connector Pin Description
Figure 3-1 shows the pin assignments for the Lab-PC+ I/O connector. This connector is located
on the back panel of the Lab-PC+ board and is accessible at the rear of the PC after the board has
been properly installed.
Warning: Connections that exceed any of the maximum ratings of input or output signals
on the Lab-PC+ may result in damage to the Lab-PC+ board and to the computer.
This includes connecting any power signals to ground and vice versa. National
Instruments is
NOT liable for any damages resulting from any such signal
connections.