Filter
Top Products
Chapter 13 Interfaces
ZyWALL USG 300 User’s Guide
355
Figure 287 Configuration > Network > Interface > Auxiliary
Each field is described in the table below.
Table 81 Configuration > Network > Interface > Auxiliary
LABEL DESCRIPTION
General Settings
Enable
Interface
Select this to turn on the auxiliary dial up interface. The interface
does not dial out, however, unless it is part of a trunk and load-
balancing conditions are satisfied.
Interface
Properties
Zone This field is read-only and displays the zone to which the auxiliary
interface belongs.
Description Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%- characters, and it can be
up to 60 characters long.
Port Speed Select the speed of the connection between the ZyWALL and external
computer.
Dialing Type Tone - select this if the telephone uses tone-based dialing.
Pulse - select this if the telephone uses pulse-based dialing.
Initial String Enter the AT command string to initialize the external modem.
ATZ is
the most common string, but you should check the manual for the
external modem for additional commands.
Auxiliary
Configuration